scarf joint strength

 > If the joints are properly done, they'll be about as strong and stiff as
the
 > stock. No beefing up will be needed.

the glue join won't need beefing (if done properly, obviously) but the ply
may fail if it's poor quality... up to you, just use some intelligence when
moving the three sheets once joined.

Al
 >> Stay informed about: scarf joint strength 

okay, thanks. Patrick

----------
In article , "Al"
wrote:


  >> If the joints are properly done, they'll be about as strong and stiff as
 > the
  >> stock. No beefing up will be needed.
 >
 > the glue join won't need beefing (if done properly, obviously) but the ply
 > may fail if it's poor quality... up to you, just use some intelligence when
 > moving the three sheets once joined.
 >
 > Al
 >
 >
 >> Stay informed about: scarf joint strength 

Patrick wrote:

 > I need to scarf 3 sheets of half inch ply together before I can start
 > lofting, for a stitch and glue boat I,m building.
 > How strong is the joint once glued and will I have to beef up the joint with
 > battens to enable me to handle the ply once together?
 > Patrick
 > 8-1 was the ratio I was going to use.

Dont forget, if you apply a batten before the ply is attached to your hull, it
won't curve in the area of the batten as much as in the rest of the stock, so
you will have a "flat" spot...if the batten goes on after, you've got to fit a
flat piece to a curve. A well made scarf is enough.

Beeswax
 >> Stay informed about: scarf joint strength